DRAGONFLY Trimarans User Forum

Quick 3d models for DF800 hulls.

Mainhull:
https://sketchfab.com/models/a18856e47a ... ef54346500

Float:
https://sketchfab.com/models/e57ccc05b5 ... e5edcc784a

Quick Cockpit:
https://sketchfab.com/models/f86c0f1705 ... e47ee9f815

Raw scan data of front beam:
https://sketchfab.com/models/dde7ccaaae ... 16b88c65d4

mesh density reduced due sketchfab limitations

Raw Beam end:
https://sketchfab.com/models/ee7c302ca2 ... 35fba27219

Is it possible to 3D print a model from these models?

from the hull models 3d printing should be no problem. Raw scan data has holes so i think those are not good for printing without some modifications...